Fuel Fittings, Lines & Clamps

Our fuel line kit replaces all the feed and return rubber fuel hoses in the engine compartment, between the engine and the fuel tank, and at the fuel pump and filter.  It also includes the upper and the lower fuel injector seals. New fuel line...

Replace your 33+ year-old plastic fuel rails with these billet aluminum fuel rails. Old plastic parts for the coolant or fuel system are the Achilles heel of your Vanagon. Plastic degrades over time and it's not a question if it will fail, but when it...

This complete set of fuel lines contains enough tubing to replace all the hard lines in the VW Vanagon.  While the factory lines don't usually degrade over time like the rubber fuel hoses do, we have seen instances of lines with physical damage or...

Quality pinch clamp pliers for Oetiker-style clamps. These are used to properly install full-circle 'ear'-style pinch clamps. This is absolutely a tool you should have in your toolbox.  We use Oetiker-style clamps on all our fuel-system...

This excellent quality fuel injection hose replaces the original 7.9mm hose used from the pump to the engine, all around the engine, and then returning to the fuel tank. The 30R14 rating mean that it's ethanol and biodiesel safe. Sold by the foot...

SOLD BY THE FOOT. 12mm fuel line runs from the tank to the pump. This is the feed line to the pump, it is not for a high-pressure location. 2 feet is the normal length required (in which case you would order quantity 2). Please note that a 2-foot length...

Sold by the foot, this 6.3mm fuel line is used on the fuel tank breather/vapor system and replaces the original 5mm hose. It is not the fuel line that runs to the engine. Made by Gates. Ref ID: 27068

These are the smooth clamps (non-serrated) that we recommend using the rubber fuel line (not cloth). There are approx. 20 clamps if you are replacing all of the clamps for the pressurized lines. (This clamp is also the clamp we recommend using with our...

Excellent quality stainless steel pinch clamp. These are commonly used to seal the fuel expansion tank hoses to the plastic lines that run from fuel tank to expansion tank in your Vanagon. Note: these are Oetiker style pinch clamps.  You'll need a...

Stainless steel hose and tube clamp.  Commonly used in the VW T3 Vanagon to clamp the fuel vapor hoses which run from the fuel tank to the fuel expansion tanks in the front wheel wells.  Clamping range - 11.5-14.00 mmThis is an Oetiker-style...

This fuel clamp is used with the 5mm low pressure cloth fuel hose in the fuel tank breather system.  This is the small hose that travels to and from the fuel expansion tanks in 2WD and in the rollover valves in the Syncro. In 2WD Vanagons, there are...